娄底附近有没有服务

 Hoist manufacturer

Hand machine: 13462251112 (wechat)

Email: [email?protected]

Address: Weibin Industrial Park, Xinxiang City

Current location: home page > News and information News and information

In order to strengthen the safety management of bucket elevator, the following aspects should be done

Article source: admin release date: May 16, 2020

The shape and position of the feed inlet of the bucket elevator are generally determined by the design of the equipment manufacturer. In the process layout design, as long as the materials can enter the feed inlet smoothly through the feed chute and evenly spread in the width direction of the feed inlet. However, sometimes due to improper design of process layout, or due to the site limitation of technical transformation project, the slip angle of the feed chute in front of the feed inlet is not suitable, and the position of the feed inlet can not meet the requirements of smooth feeding. At this time, it is necessary to adjust the position or size of the feed inlet, so as to achieve the purpose that the feed chute angle is appropriate and the feeding is suitable for the loading of the hoist.

With the development of society, Bucket elevator More and more widely used. More and more cement plants are using Gladiator hoists to improve the transportation of cement. Bucket elevator is one of the important equipment in cement plant. Security is important. Strengthening the safety management of hoist is the key to enterprise development.

 Bucket elevator

In order to strengthen the safety management of bucket elevator, the following aspects should be done:

1. Do preventive work to ensure safe operation of equipment

2. Do a good job in safety inspection, find and deal with hidden dangers in time

3. Cultivate workers' safety knowledge and awareness, and fundamentally solve hidden dangers.

The safety management of bucket elevator has always been the focus of attention. Therefore, it is necessary to increase the safety protection measures and safety management level of the hoist in cement plant. It is necessary to carefully check the construction equipment, find and deal with problems in time, and eliminate hidden dangers. At the same time, it is necessary to strengthen the safety awareness of operators and deal with problems in time to ensure the safe operation of the hoist.

The assembly and debugging of planetary gear reducer of bucket elevator is usually more complicated, which will not be introduced here. Planetary gear reducers assembled and commissioned by the manufacturer are recommended. Do not reassemble and Commission on site (if it is necessary to reassemble and debug due to maintenance, contact the manufacturer for assembly and commissioning), just press the following steps to adjust:

1. Screw the base, motor and reducer together to find the concentric and end face of the motor and reducer into the shaft.

2. Put the above combination on the adjusting horn, and then take the center line of the lifting spindle device as the installation reference to correct the height and tilt error of the center line of the spindle device and the center line of the reducer shaft. To 0.3 mm. After meeting the requirements, tighten with foot screws.