娄底附近有没有服务

 Hoist manufacturer

Hand machine: 13462251112 (wechat)

Email: [email?protected]

Address: Weibin Industrial Park, Xinxiang City

Current location: home page > News and information News and information

How to prevent material blockage of bucket elevator?

Article source: admin release date: July 9, 2019

How to block substances. stay Bucket elevator In the process of operation, if the operation is improper, it is easy to cause material blockage, even shut down the machine, which not only delays the normal production, but also greatly reduces the use of the hoist. life. This paper summarizes how to cause blockage and how to solve it.


The first reason is that the feeding speed at the feed inlet is too fast, which results in the feed rate being much higher than the feed rate, resulting in material accumulation in the base and causing material blockage.


Solution: strictly control the feeding speed of the feed inlet, keep the constant feeding speed, avoid too fast or too slow feeding speed, too fast will lead to material blockage, too slow will not achieve the predetermined output.


Reason 2: the material is blocked by too much moisture in the material or fiber impurities in the material.

To solve this problem, open the access door next to the base, remove fibers and other debris, and open the blocked material in the channel.

How to solve this problem Bucket elevator The problem of leaning to one side?

? Bucket elevator Tilting to one side can be divided into two cases. One is inclined during installation, the other is inclined during use. ?


There are two reasons for the former. 1. There was no good school level at the time of installation. 2. It is caused by the steel sheet used in the intermediate housing section. In the former case, only the installation technicians sent by the manufacturer need to carry out school level operation during the installation of the base, intermediate shell and head; in the latter case, only rescue measures and angle iron are required. Reinforce the box with iron bars or fix the boxes on both sides of the box with walls to achieve the reinforcement effect. The latter situation will not occur in the production of cranes. We are customer based. After in-depth discussion between both parties, the steel plate thickness is selected. Generally, 1.5mm, 3mm thick steel plate is used to make the box.


In the process of use, the problem of tilting the box occurs. It is necessary to observe whether traction components such as belts, chains and plate chains are inclined to one side, and whether the hopper is displaced or displaced. Once found, it should be corrected in time to avoid tilting. The bigger it is